2.2.3
Connecting by Ethernet interface
The Ethernet interface supports the following two types of environment:
100BASE-TX
10BASE-T
The factory setting of Ethernet is set as Auto, enabling automatic switching to 100BASE-TX or
10BASE-T.
The following procedure explains how to connect by the Ethernet interface:
Procedure
Insert the Ethernet interface cable connector to
the interface connector.
Use only interface cable suitable for the network
connection in use.
Switch on the printer.
When you want to fix the transmission speed for 10BASE-T or 100BASE-TX connector or
change the printer setting according to the environment in use while connected to 10BASE-T/
100BASE-TX connector, refer to "5.3 Common Menu Items".
2.2 Connecting Cable
21
2