Xerox document centre285 series User Manual page 96

4.3 Configuring the Printer Drivers
Finishing
Select where to staple your printed document.
Paper sizes that can be stapled include A5, B5, A4, 8.5×11", B4, A3, 8.5×13", 8.5×14", 8K
and 11×17".
Stapling
Options include:
Enabled only if all of the following conditions are met:
- Finisher has been selected for Paper Output Options on the Printer tab;
- Hard Disk has been selected on the Printer tab;
- Finisher Tray Upper has been selected for Output Destination on the Paper/Output
tab;
- Collated has been selected for Collated Settings;
- more than 1 has been selected for Copies on the Paper/Output tab.
4
The finisher can staple up to a maximum of 30 sheets.
Document Options
Enables special output document options for print jobs. Options include:
None (default)
The print job is output normally.
First Sheet
Allows the paper source for the first sheet in your job to be different from the rest of the
printed output sheets. The paper size must be the same as the body of the document.
When this is selected, a drop-down list, Feed First Sheet from will become available for
you to choose your paper source for the First Sheet. Options include:
84
None (default)
Staple function off.
Top Left Corner
Top Right Corner
Bottom Left Corner
Bottom Right Corner
Auto (default)
Tray 1
Tray 2
Tray 3
Tray 4
(available only if Tray 4 has been selected for Paper Source Options on the
Printer tab)
Bypass Tray
(available only if all of the following conditions are met:
- on the Printer tab, Bypass Tray has been selected;
- on the Paper/Output tab, 1 Sided Print has been selected for 2 Sided Print and
Finisher Tray Upper has not been selected for Output Destination)