Xerox document centre285 series User Manual page 128

5.3 Common Menu Items
Menu item
IPP
5
116
The following items are to be set when using IPP:
Port Status
Sets the port status of the IPP port when the power is switched on. The
candidate values are:
• Enable
• Disable (default)
To set IPP to Enable, you will need to set the IP address .
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
Print Mode
Sets the printer language. The candidate values are:
• Auto (default)
The language to be used will be determined automatically
• PCL
• PS (available only when PostScript Kit is installed)
When the value is set to Auto, and if the printer language used cannot be found by the
automatic printer language detection feature or it is not the selected printer language,
the data may be erased.
PJL
Sets whether to enable the PJL commands sent from the computer. The
candidate values are:
• Enable (default)
• Disable
TBCP Filter
Sets whether to enable the TBCP filter when processing PostScript data.
Available only when PostScript Kit is installed. The candidate values are:
• Enable
• Disable (default)
Access Control
Sets whether to enable the access control when entering/exiting the pause
state or canceling/deleting print job. The candidate values are:
• Enable
• Disable (default)
Explanation