Xerox document centre285 series User Manual page 129

Menu item
IPP DNS
(con't...) Sets whether to use the name registered in the Domain Name Server (DNS)
when it is recognizing the printer. The candidate values are:
• Enable (default)
• Disable
Add Port No.
Sets the number for the added port. The candidate values are:
• 80 (default)
• 0
• 8000-9999
Connect Time-Out
Sets the time to disconnect after data transmission is disrupted. The range of
setting is between 0-65535 seconds. Default is 60 seconds.
USB The following items are to be set when using USB:
Port Status
Sets the port status of the USB port when the power is switched on. The
candidate values are:
• Enable
• Disable (default)
If the memory is not enough when the Port Status is set to Enable, it may be set to
Disable automatically. When this happens, either set the Port Status of other ports not
in use to Disable or change the memory allocation.
Print Mode
Sets the printer language. The candidate values are:
• Auto (default)
• PCL
• PS (available only when PostScript Kit is installed)
When the value is set to Auto, and if the printer language used cannot be found by the
automatic printer language detection feature or it is not the selected printer language,
the data may be erased.
PJL
Sets whether to enable the PJL commands sent from the computer. The
candidate values are:
• Enable (default)
• Disable
The DNS name will be used.
The printer will be recognized by its IP address.
The language to be used will be determined automatically
5.3 Common Menu Items
Explanation
5
117