Service Menu - OM POWER OM2000+ User Manual

5.2.3. Service menu

In the Service menu it is possible to verify software version. This menu allows user to check total
operating hours and listing in the memory, where reported faults and warning messages are stored.
You can display particularly warning messages and particularly error messages. See chapter 6 for more
information regarding to warnings and faults occurrence. There you can find a coding table together
with a limited values for the safety circuits activation also.
In the Service menu a value of EBS1 and EBS2 can be automatically adjusted. This is used for example
when it is necessary to make adjustment after replacing the tube. Automatic control of EBS, however,
can be done at any time. EBS1 default value is 20mA of Ip, EBS2 default value is 250mA of Ip.
Minimal turns of the blower are the matter of settings in the Service menu, too.
Use UP or DOWN button to set second mode.
The fan will activate together with PTT.
Type of supported TCVR and working
Press ENT to confirm settings.
frequency are visible on the display.
Use UP or DOWN button to set the third
mode. The fan will turn always when PA will
Type of supported TCVR and working
be ON. Press ENT to confirm settings. Press
ESC twice to release Settings mode.
frequency are visible on the display.
Use Service menu after replacing the tube.
This is step No. 1.
Type of supported TCVR and working
To enter Service menu, go to the MENU first,
frequency are visible on the display.
then press SERV button.
Use UP or DOWN button to check software
version.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
19