Test Project - Siemens SIMATIC TP 270 Operating Instructions Manual

Prepare and backup project
7.2 Transfer
Autostart application
• Path
• Wait
Press the "OK" button or <ENTER> key to confirm the settings currently defined for the
transfer options. Ensure that no buttons have been selected. The dialog is closed and the
Windows CE Control Panel is displayed.
Press the close symbol or <ESC> key to close the dialog and open the Windows CE Control
Panel. Any modifications made to the settings are rejected.
Note
If the HMI device is in transfer mode while changes are made to the transfer settings, the
settings only take effect after the transfer function is restarted. This can occur when the
Control Panel is selected via the Windows Start menu in order to modify the transfer
properties.
7.2.4

Test project

Introduction
There are three ways to test a new project:
• Test the project on the configuration computer
• Test project offline
• Test project online
Test the project first on the configuration computer using the simulator. Then, always test the
project online.
The material supplied with WinCC flexible contains a simulation program which can be used
to test the project on the configuration computer without the necessity of connecting a PLC
or HMI device. Detailed information on this is available in the "WinCC flexible" user manual
and in the WinCC flexible online help.
7-8
The memory location for runtime is defined here. This is the application where the project
runs under Windows CE.
It is possible to define the number of seconds the loader should remain on screen before
the runtime is started (1 s, 3 s, 5 s, 10 s or constantly). If no runtime software is available,
the device automatically switches to transfer mode.
Notice
With the exception of the "Wait" field, do not change default settings in the fields when
working with WinCC flexible. Otherwise, the HMI device can no longer start the project.
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0