Siemens SIMATIC TP 270 Operating Instructions Manual page 237

Number Effect/cause
130002 The action was not executed.
130003 No data medium is inserted. The process is
stopped.
130004 The data medium is write-protected. The process is
stopped.
130005 The file is write-protected. The process is stopped.
130006 No access to file is possible. The process is
stopped.
130007 The network connection is interrupted.
Data records cannot be saved or read over the
network connection.
130008 The storage card is not available.
Data records cannot be saved or read to the
storage card.
130009 The specified directory is not on the storage card.
The files that are saved in this directory are not
saved when the HMI device is switched off.
130010 The maximum nesting depth can be exhausted, for
example, when a value change in a script results in
the initiation of another script. The second script in
turn has a value change resulting in the initiation of
another script and so on.
The configured functionality is not provided.
140000 Online connection to the PLC has been
successfully established.
140001 Online connection to the PLC has been
disconnected.
140003 No tag updating or writing is executed.
140004 No tag updating or writing is executed because the
access point or the subrack configuration is
incorrect.
140005 No tag updating or writing is executed because the
address of the HMI device is incorrect (possibly too
high).
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
Remedy
Close the other programs.
Delete files no longer required from the hard disk.
For example, check if
The correct data medium is being accessed
•
The data medium is inserted
•
Check whether access has been made to the correct
storage medium. Remove any write protection.
Check whether access has been made to the correct file.
Modify the file attributes, if necessary.
For example, check if
The correct file is being accessed
•
The file exists
•
Another action is preventing simultaneous access to
•
the file
Check the network connection and correct the reason for
the disruption.
Insert the storage card.
Insert the storage card.
Check the configuration.
-
-
Check the connection and whether the PLC is switched
on.
Check the parameter definitions in the Control Panel
using "Set PU/PC interface".
Restart the system.
Verify the connection and check whether the PLC is
switched on.
Check the access point or the subrack configuration
(MPI, PPI, PROFIBUS) in the Control Panel with "Set
PU/PC interface".
Restart the system.
Use a different HMI device address.
Verify the connection and check whether the PLC is
switched on.
Check the parameter definitions in the Control Panel
using "Set PU/PC interface".
Restart the system.
Appendix
A.2 System alarms
A-11