Transfer mode directories
The "Directories" tab can be used to specify the following paths (refer to figure below).
Figure 7-2
Project File
The predefined storage location for the project file can be changed here. The internal Flash
memory or external Flash cards can be set. During the next transfer process, the project is
stored in the storage location specified.
Project backup
The predefined storage location for your project source file can be changed here. This file
can be used for restoring (uploading) the configuration. External Flash cards or network
connections can be set.
TP 270, OP 270, MP 270B (WinCC flexible)
Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0
"Transfer Settings" dialog, "Directories" tab
Prepare and backup project
7.2 Transfer
7-7