Configure The Network; Test The Serial Ports - Siemens Climatix POL8T1.4X/STD Basic Documentation

Note:
Siemens
Building Technologies
6.3

Configure the Network

To configure the network setting of the Climatix touch panel:
1. Press Network.
2. Choose either automatic address assignment via DHCP, or a Static IP for the
Climatix touch panel.
•
If DHCP is chosen, the Climatix touch panel obtains an automatic IP
from a DHCP server on the Ethernet.
•
If Static IP is chosen, enter valid values in the IP address, Subnet
Mask, Gateway, and DNS address text box.
3. Press Ok to confirm.
The button is not functional in the current release.
6.4

Test the serial ports

To test the serial ports:
1. Press Serial.
2. Connect the desired serial port (for example, COM1) on the Climatix touch
panel to a PC with serial port monitor software running.
3. Configure the parameters in both HMI setting and the monitor software as the
same. Below is an example of the parameter settings:
•
Select serial port: COM1
•
Baud rate: 9600
•
Data bits: 8
•
Parity: None
•
Stop bit: 1
Climatix touch panel
Configuring the Climatix touch panel
23/30
A6V10445442
_en--_a
2015-06-30