Table of Contents
Advertisement
No.
Component
3
Firmware
Upgrade
Recovery
Switch
4
Audio Ports
5
USB 2.0 Hub
6
Reset Switch
7
Power LED
During normal operation and while performing a firmware
upgrade, this switch should be in the NORMAL position. If a
firmware upgrade operation does not complete successfully,
this switch is used to perform a firmware upgrade recovery.
See Firmware Upgrade Recovery, page 58, for details.
The cables from your main speakers and main microphone
plug in here. The speakers and microphone plugged in here
have priority over those in the rear panel.
USB 2.0 peripherals (printers, scanners, etc.) can plug into this
port (this may require an extra power adapter).
Pressing this switch performs a system reset. When the
system is reset, the switch beeps, and the port LEDs flash in
succession until the reset is complete. After the reset is
complete you can login again.
Note: This switch is recessed and must be pushed with a small
object, such as the end of a paper clip or a ballpoint pen.
Lights to indicate that the switch is powered up and ready to
operate.
Chapter 1. Introduction
Description
7
Advertisement
Table of Contents
