Table of Contents
Advertisement
5
Command Parameters
Overview
Parameters
software such as CCS Navigator to access these parameters or use the 6800+ Web GUI. See
the respective software user manual for more information on usage. In Table 5-1 on
page 23, each branch of the parameter tree is separated by a 'greater than' sign '>'.
When using the serial port command line interface or telnet, use a slash "/" as a separator
instead of ">", and include a separator before the parameter name.
SRC6800+ Commands are arranged into three groups:
Configuration Commands
Use these commands to set module parameters.
Status Commands
Use these commands to verify almost any parameter.
Alarm Commands
Use the commands in this section to monitor alarm states.
on page 23 lists all parameters and options for the SRC6800+. Use control
Configuration > RF[1–4]
Configuration > BISS
on page 24
Configuration > Dmx
on page 25
Configuration > Network
Configuration > Control
Status > Dmx
on page 27
Status > RF [1–4]
on page 27
Status > Ethernet
on page 28
Status > Sys
on page 28
Alarms
on page 28
on page 23
on page 26
on page 27
Copyright © 2011, Harris Corporation
21
Advertisement
Table of Contents
