Table of Contents
Advertisement
18
Chapter 4
Operation
How to Check Hardware and Software Versions
Configuration Procedures
How to Configure an RF Input Source
Copyright © 2011, Harris Corporation
See the RCP-CCS-1U Installation and Operation Manual, CCS software application user
manual, or CCS software application online help for information on viewing software and
hardware version numbers.
These sections describe the SRC6800+ input configuration parameters.
•
How to Configure an RF Input Source
•
How to Configure the ASI Interface as the Input Source
This section describes how to configure the SRC6800+ to provide either a single or a
multiple-program transport stream.
•
How to Configure Transport Stream Output
Use these steps to extract a single, or a multiple-program transport stream from a signal
entering the system through its RF input.
1
Configure the various RF parameters on the interface carrying the RF signal. Set the RF
values for the signal on the satellite distribution network.
Configuration > RF2 > ...
Frequency = <value>
Local Oscillator Frequency = <value>
Information Rate = <value>
Modulation = <value>
Symbol Rate = <value>
LNB Voltage = <value>
LNB Tone = <value>
Pilot = <value>
2
Specify the input source as RF.
Configuration > DMX > Input = RF
3
Specify the desired RF input.
Configuration > DMX > RF Select = 2
The module now uses the signal on the RF 2 interface as input.
See
How to Configure Transport Stream Output
configuration steps required to decode or to pass through the incoming signal.
on page 18
on page 19
on page 19
on page 19 for additional
Advertisement
Table of Contents
