Table of Contents
Advertisement
How to "Discover" the Module in Navigator
1
Click Options > Discovery to open the Discovery Options dialog.
Figure 2-1 Discovery Options Dialog
2
If the Products for Discovery column lists the frame containing the module you have just
installed (Note: Check the IP Address column as well to be sure) then:
a
b
c
3
If the frame of containing the module you have just installed is not listed, then click the
Add... button to open the Add Host dialog.
a
b
c
d
e
4
Click OK to dismiss the Discovery Options dialog.
5
If the Discovery Pane is not visible, click Tools > Discovery to reveal it.
6
Click the Start button to begin the Discovery session.
7
Wait until the Status window indicates "Discovery Completed".
8
Click the Save button.
9
Drag the icons of any discovered pieces of equipment from the Discovery branch of the
navigation tree to the Network branch.
10
Click the Save button to save the discovered items as network elements.
The discovered items are now ready for further configuration and monitoring.
Place a check mark in the Hosts column next to the module.
Click the Apply button, then click the OK button.
Skip to
step 4
below
Enter the IP Address of the 6800-series shelf in the Host IP field.
Click the Options... button to open the Communication Settings dialog
Choose the Point-to-Point option from the Communication Type drop-down
Click OK to dismiss the Communications Settings dialog
Click OK to dismiss the Add Host dialog.
SRC6800+
Installation and Operation Manual
Copyright © 2011, Harris Corporation
11
Advertisement
Table of Contents
