Table of Contents
Advertisement
10
Chapter 2
Installation and Navigation Discovery
Pre-Installation Process
Module Installation
Required Frames and Back Connector Types
Installing and Removing Application Modules
Copyright © 2011, Harris Corporation
Perform the following steps before installing the SRC6800+.
Note: Contact your Customer Service representative if parts are missing or damaged
1
Unpack the module.
2
Check the equipment for any visible damage that may have occurred during transit.
3
Confirm receipt of all items on the packing list. The following items should be included.
Ordered Product
SRC6800+
4
Remove the anti-static shipping pouch, if present, and all other packaging material.
5
Retain the original packaging materials for possible re-use.
See
Unpacking/Shipping Information
servicing.
The SRC6800+ module has a double-width back connector that can be installed in a
6800+XF.
See the 6800+ Frame Installation and Operation Manual for details on installing back
connectors in a 6800+ frame.
These modules require no specialized installation or removal procedures. However, if
installing both front and rear modules, ensure that the back module is installed first before
plugging in the front module. When removing both the front and rear modules, ensure that
the front module is unplugged from the frame first, before removing the rear module.
1
See the 6800+ Frame Installation and Operation Manual for information about installing and
operating an 6800+ frame and its components.
2
See the 6800+ Safety Instructions and Standards Manual for important information about safely
installing your module.
Once the SRC6800+ module is installed, the appropriate input and output cables can be
connected.
Content Description
One SRC6800+ front application module
One double-slot back connector
One documentation and firmware CD.
for information about returning a product for
Advertisement
Table of Contents
