Table of Contents
Advertisement
4
Operation
This chapter explains how to configure the SRC6800+.
How Commands Are Documented
In Navigator, each element in this command line represents a distinct level in the command
tree. The last element in the command line represents a parameter value selection or entry.
Procedures in this chapter list commands in a single-line format.
Configuration > Network > IP Address = 123.123.123.123
An expansion of this example instruction would appear as follows.
1
Select the Configuration branch.
2
Select the Network branch.
3
Choose the IP Address parameter.
4
Set the 'IP Address' parameter to 123.123.123.123.
See the RCP-CCS-1U Remote Control Panel manual for Ethernet interface document for
information on how to operate this product remotely.
General Operating Procedures
How Parameter Changes are Applied
When setting the configuration parameters on the SRC6800+, observe the following:
1
Parameter changes take immediate effect. However, the module requires up to 30 seconds
to save the latest change.
2
New settings are saved after 30 seconds. Once saved, these settings are restored in the
event the module loses power or is restarted.
Copyright © 2011, Harris Corporation
17
Advertisement
Table of Contents
