Mitsubishi Electric TX10U User Manual page 6

• Do not place the projector in the following places.
Otherwise, a short circuit, heat generation, or melt-
ing of the power cord coating may occur, causing
fire, electric shock, product failure, or deformation.
• Outdoors or non air-conditioned place
• Place where a gas such as a hydrogen sulfide is
generated (i.e. hot spring)
• Place where there is too much salt such as near
the coast
• Be sure to use this projector at an altitude of less
than 1500 meters.
Do not place a container containing water
or other liquid on the projector.
If water spills on or enters the projector, it may result in
fire or electric shock.
Do not put any object that is heavy or larger
than the outer frame on the projector.
Otherwise, the object may fall losing its balance and
cause injury.
Do not subject the projector to strong
shocks or vibrations. Do not handle the
projector roughly.
The projector may be damaged, resulting in fire or
electric shock.
When removing the lamp from the ceiling-
mounted projector
Be sure to use the lamp replacement attachment
designed specifically for this projector when replacing
the lamp with a new one. Lamp fragments may fall from
the inside if the lamp were broken.
Do not put the projector in the soft case
with the power cord and cables connected.
The projector, power cord, or cables may be damaged.
EN-6