Mitsubishi Electric TX10U User Manual page 55

Others (continued)
Problem
Abnormal sound is heard.
Images are not 3D.
* Use commercially
available 3D glasses
supporting the DLP™
Link™ system. No 3D
glasses are supplied with
the projector.
There is something wrong
with the 3D images.
* Use commercially
available 3D glasses
supporting the DLP™
Link™ system. No 3D
glasses are supplied with
the projector.
The 3D glasses don't turn
on.
* Use commercially
available 3D glasses
supporting the DLP™
Link™ system. No 3D
glasses are supplied with
the projector.
If the following problem occurs after the lamp is replaced, check the following first.
Problem
The projector does not
turn on.
The STATUS indicator
blinks.
Solution
• Because the color wheel spins at a high speed, metallic sounds may be heard in
rare occasions. Such symptom is not a malfunction.
• Is the 3D mode of the projector set properly for the image?
Set 3D FORMAT in the 3D menu of the projector properly for the image (AUTO
, SIDE BY SIDE
• View 3D image from the front of the screen. At the angle to the screen, you may not
be able to view proper 3D images.
• Is there any obstacle between the 3D glasses and the screen? Or, is there any
sticker or label over the sensor of the 3D glasses?
The 3D glasses work by receiving signals of the images being viewed. Check
that there is no obstacle between the 3D glasses and the screen.
• Are you viewing images from a very close distance?
Viewing images from a very close distance may not obtain the 3D effect. View
images from a proper distance.
• The 3D glasses may become out of sync due to fluorescent light. Turn off the
fluorescent light.
• Are the 3D glasses turned off?
Turn on the 3D glasses.
• The signals listed in the table on page 61 can be displayed in 3D format. You cannot
view other signals in 3D format even when you set 3D FORMAT in the 3D menu to
AUTO , SIDE BY SIDE
• You may not obtain the 3D effect depending on the capabilities of your computer
(including the graphic board, memory, and CPU).
• Some 3D glasses may not work with this projector. Ask the dealer for details.
• Depending on the 3D image status, you may feel something wrong with the 3D
images.
Switch the 3D SYNC INVERT setting of the projector to check whether or not
such feeling is eliminated.
• The 3D glasses may become out of sync due to fluoescent light. Turn off the
fluorescent light.
• View 3D images from the front of the screen. At an angle to the screen, you may not
be able to view proper 3D images.
• Are the batteries of the 3D glasses still working?
If the 3D glasses don't activate even when you turn on the power switch, replace
or charge the batteries of the 3D glasses. For details, see the user manual of the
3D glasses.
Solution
• Fit the lamp cover securely. (See pages 48 or 49.)
• Reset the lamp operating time. (See page 49.)
• Reset the lamp operating time. (See page 49.)
, TOP AND BOTTOM
, TOP AND BOTTOM
EN-55
, or FRAME SEQUENTIAL
, or FRAME SEQUENTIAL
).
.