Mitsubishi Electric TX10U User Manual page 38

How to adjust the image supplied from the computer using the menu:
Carry out the following procedures according to the symptoms.
Wide strips appear ...........................................................
The projected image flickers.
The projected image is blurred.........................................
The projected image is displaced horizontally .................
The projected image is displaced vertically .....................
The top part of the image flags ........................................
A solid black or solid white appears in the image............
The motion doesn't run smoothly ....................................
Noise appears on the right or left half of the image .........
Noise appears on the top or bottom part of the image....
1. Display the SIGNAL menu.
2. Press the or button to select a setting to adjust.
3. Adjust the selected setting by pressing the
To cancel the menu:
4. Press the MENU button.
• Do not change the settings of the Signal menu for ordinary use.
Simple method to adjust the image position
To adjust the horizontal position:
1. Align the left edge of the image with the left side of the screen by adjusting HORIZ. POSITION. Then, align the
right edge of the image with the right side of the screen by adjusting TRACKING.
2. Repeat step 1 above to complete the adjustment of the horizontal position.
To adjust the vertical position:
3. Align the upper edge of the image with the upper side of the screen by adjusting VERT. POSITION.
LPF (Progressive filter)
You can select whether or not to enable the LPF. Vertical or horizontal streak noise may appear on the projected
image, depending on the type of the DVD player or game console you use. In such a case, you can reduce such streak
noise by enabling the LPF. However, projected images become softened slightly.
Adjust TRACKING in the SIGNAL menu.
Adjust FINE SYNC. in the SIGNAL menu.
Adjust HORIZ. POSITION in the SIGNAL menu. Every
time the button is pressed, the image moves to the
right. Every time the
moves to the left.
Adjust VERT. POSITION in the SIGNAL menu. Every
time the button is pressed, the image moves down.
Every time the
up.
Change the setting of HOLD in the SIGNAL menu.
Select ON
BEGIN or END to minimize the flagging.
Adjust CLAMP POSITION or CLAMP WIDTH in the
SIGNAL - USER menu
Adjust VERT. SYNC. in the SIGNAL - USER menu.
Select AUTO for normal use.
Adjust SHUTTER(LS) or SHUTTER(RS) in the SIGNAL -
USER menu.
Adjust SHUTTER(U) or SHUTTER(L) in the SIGNAL -
USER menu.
or button.
EN-38
button is pressed, the image
button is pressed, the image moves
, press the ENTER button, and adjust