Network Menu - Mitsubishi Electric TX10U User Manual

NETWORK menu

ITEM SETTING
PROJECTOR NAME *****...
NETWORK
ON
CERTIFICATION
NETWORK
ENTER
PASSWORD
IP CONFIG
ENTER
DHCP ON
OFF
IP ADDRESS
***.***.***.***
SUBNET MASK
***.***.***.***
DEFAULT
***.***.***.***
GATEWAY
MAC ADDRESS xx-xx-xx-xx-xx-xx
SAVE SETTINGS OK
AMX DEVICE
OFF
DISCOVERY
NETWORK RESET
OK
NETWORK
OK
RESTART
FUNCTION
Set the name to identify the projector. Enter up to 15 characters (alphabets
or numeric characters). (See page 39.)
Select whether to enable the network certification or not. Select ON for
/ OFF
normal use. (See page 39.)
Set the password for the certification of PJLink™, ProjectorView Global+
and remote control via LAN. (See page 39.)
Select this setting for IP Configuration. (See page 40.)
Select this setting when you obtain IP CONFIG automatically by DHCP
server.
Select this setting when you set IP CONFIG manually.
Press the ENTER button to set IP ADDRESS. When DHCP is set to ON, you
cannot change this setting
Press the ENTER button to set SUBNET MASK. When DHCP is set to ON,
you cannot change this setting.
Press the ENTER button to set DEFAULT GATEWAY. When DHCP is set to
ON, you cannot change this setting.
Displays MAC ADDRESS.
Saves the IP CONFIG settings. When the IP CONFIG is not changed, you
cannot select SAVE SETTINGS.
Use this setting when using an AMX controller.
/ ON
Resets the Network Setting. (See page 42.)
Press the ENTER button to restart the network function.
EN-32