Dataprobe iBoot G2+ Manual page 24

set time server <dotted decimal>
set time enable <yes | no>
get time
set event <1-8> date <mm/dd/yyyy>
set event <1-8> time <hh:mm>
set event <1-8> repeat < minute | hour |
day>
set event <1-8> mult <0-999>
set event <1-8> action <on | off | cycle >
set event <1-8> delete
Prompts
User >
Password >
iBoot >
iBoot Reboot Required >
V110120E
Name Date Time Repeats Action
1. Event Name mm/dd/yyyy hh:mm Annually Power On
2. Event Name mm/dd/yyyy hh:mm Annually Power On
3. Event Name mm/dd/yyyy hh:mm Annually Power On
4. Event Name mm/dd/yyyy hh:mm Annually Power On
5. Event Name mm/dd/yyyy hh:mm Annually Power On
6. Event Name mm/dd/yyyy hh:mm Annually Power On
7. Event Name mm/dd/yyyy hh:mm Annually Power On
8. Event Name mm/dd/yyyy hh:mm Annually Power On
This command is used to set the IP Address of a
network time server.
This command enables or disables the use of the time
server and scheduled events.
Displays the current time and time server (when
enabled)
Current Time: 16:10:41 01/27/2010
Server: 64.90.182.55
Time Zone: ‐4
This command is used to set the scheduled action's
start date.
This command is used to set the time the scheduled
action will occur in 24 hour format.
This command is used to set the increments for
repeating scheduled actions
This command sets how often the event will repeat, the
number of increments (as set by the command above)
before the next event.
This command is used to set the scheduled action.
This command deletes the scheduled action.
The CLI will use the following prompts:
This prompts the user to enter his user name (user or
admin). This is the first prompt that the user is
presented with.
This prompts the user to enter his password.
This is the prompt that will be displayed after the user
has successfully logged in.
This is the prompt that will be displayed whenever
there have been changes made that require a reboot.
This prompt will remain the active prompt until the
iBoot-G2+ has been rebooted.
iBoot-G2+
64.90.182.55
No
Page 24