Compass Calibration - ATN BINOX HD Operator's Manual

1.10 . C O M PA S S CA L I B R AT I O N
When the compass needs to be calibrated the word
"CAL" appears instead of the Compass Scale . To cal-
ibrate you should rotate the device on three axis as
illustrated .
NOTE
After calibrating the device please remember
that the compass will work best when holding
the BinoX parallel to the ground.
Other possible Errors:
• ERR — an error was detected (you may need to
restart the device or recalibrate the compass);
• SMF — your device is under Strong Magnetic Field (please, move away from the Magnetic
Field);
• UPD — your firmware needs to be updated .
1-7