Hpe 5510 48G Poe+ 4Sfp+ Hi - HP flexnetwork 5510 hi series Installation Manual

HPE 5510 48G PoE+ 4SFP+ HI

Figure 54 HPE 5510 48G PoE+ 4SFP+ HI front panel
(1) 10/100/1000Base-T autosensing Ethernet port
(3) Management Ethernet port
(5) Mini USB console port
(7) USB port
(9) SFP+ port
(11) Interface card status LED (SLOT)
(13) Power supply 1 status LED (PWR1)
(15) Management Ethernet port LED
Figure 55 HPE 5510 48G PoE+ 4SFP+ HI rear panel
1
(1) Grounding screw
(3) Fan tray 1
(5) Power supply 1
The HPE 5510 48G PoE+ 4SFP+ HI switch comes with power supply slot 1 empty and power supply
slot 2 installed with a filler panel. You can install one or two power supplies for the switch as required.
In this figure, two PSR720-56A (JG544A) AC power supplies are installed in the power supply slots.
For more information about installing and removing a power supply, see
power supply."
The HPE 5510 48G PoE+ 4SFP+ HI switch comes with a filler panel in the interface card slot. You
can select an interface card for the switch as required. In this figure, an LSWM2SP2PM interface
card is installed in the interface card slot. For more information about installing and removing an
interface card, see
2 3
"Installing/removing an interface
(2) 10/100/1000Base-T autosensing Ethernet port
LED
(4) Console port (CONSOLE)
(6) Port LED mode switching button
(8) System status LED (SYS)
(10) LED for the port LED mode (MODE)
(12) Power supply 2 status LED (PWR2)
(14) SFP+ port LED
4
(2) Interface card (optional)
(4) Fan tray 2
(6) Power supply 2 (optional)
card."
48
5 6
"Installing/removing a