Table of Contents
Advertisement
Figure 32 Installing an interface card with an ejector lever
Removing an interface card
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Use a Phillips screwdriver to completely loosen the captive screw on the interface card.
2.
Rotate rightward the ejector lever on the interface card.
3.
Pull the interface card out of the chassis gently along the guide rails.
4.
Verifying the installation
After you complete the installation, verify that:
•
There is enough space for heat dissipation around the switch, and the rack or workbench is
stable.
•
The grounding cable is securely connected.
•
The correct power source is used.
26
Hide quick links:
Advertisement
Table of Contents
