Installing The Switch In A 19-Inch Rack; Installation Accessories - HP flexnetwork 5510 hi series Installation Manual

Installing the switch in a 19-inch rack

Installation accessories

Table 5 Installation accessories for the HPE 5510 HI switches
Chassis
•
HPE 5510 24G 4SFP+
HI
•
HPE 5510 48G 4SFP+
HI
•
HPE 5510 24G SFP
4SFP+ HI
•
HPE 5510 24G PoE+
4SFP+ HI
•
HPE 5510 48G PoE+
4SFP+ HI
Figure 2 Rack-mounting procedure (1)
Figure 3 Rack-mounting procedure (2)
Installat
ion
Installation requirements
access
ories
Front The mounting bracket kit can be
mounting installed on the port side, power
bracket supply side, or the mid-mounting
kit position.
Front
The front mounting bracket kit must
mounting
be installed on the mid-mounting
bracket
position.
kit
•
The mounting bracket kit can be
installed on the port side or
power supply side.
•
Install the rear mounting
brackets according to the rack
depth.
If the rack depth is in the
range of 429 to 595 mm
Front and
(16.89 to 23.43 in), orient
rear
the bracket with the wide
mounting
flange inside the rack.
bracket
If the rack depth is in the
kits
range of 274 to 440 mm
(10.79 to 17.32 in) and the
distance from the rear rack
posts to the inner surface of
the cabinet door is longer
than 153 mm (6.02 in),
orient the bracket with the
wide flange outside the
rack.
7
Installation
procedure
See "Rack-mounting by
using front mounting
brackets."
See "Rack-mounting by
using front mounting
brackets."
See "Rack-mounting by
using front and rear
mounting brackets
(HPE 5510 24G PoE+
4SFP+ HI and HPE
5510 48G PoE+ 4SFP+
HI)."