Connecting The Mini Usb Console Cable - HP flexnetwork 5510 hi series Installation Manual

RJ-45
3
4
5
6
7
8
To connect a configuration terminal (for example, a PC) to the switch:
Plug the DB-9 female connector of the console cable to the serial port of the PC.
1.
Connect the RJ-45 connector to the console port of the switch.
2.
NOTE:
• Identify the mark on the console port and make sure you are connecting to the correct port.
• The serial ports on PCs do not support hot swapping. To connect a PC to an operating switch, first
connect the PC end. To disconnect a PC from an operating switch, first disconnect the switch end.

Connecting the Mini USB console cable

A Mini USB console cable has a Mini USB Type B connector at one end to connect to the Mini USB
console port of the switch, and a standard USB Type A connector at the other end to connect to the
USB port on the PC.
To connect to the PC through the Mini USB console cable:
Connect the standard USB Type A connector to the USB port of the PC.
1.
Connect the Mini USB Type B connector to the Mini USB console port of the switch.
2.
Click the following link, or copy it to the address bar on the browser to log in to download page
3.
of the USB console driver, and download the driver.
http://www.exar.com/connectivity/uart-and-bridging-solutions/usb-uarts/xr21v1410
Select a driver program according to the operating system you use:
4.
XR21V1410_XR21B1411_Windows_Ver1840_x86_Installer.EXE—32-bit operating
system.
XR21V1410_XR21B1411_Windows_Ver1840_x64_Installer.EXE—64-bit operating
system.
Click Next on the installation wizard.
5.
Signal
TXD
SG
SG
RXD
DSR
CTS
29
DB-9
2
5
5
3
4
7
Signal
RXD
SG
SG
TXD
DTR
RTS