Basic Navigation - THOMSON SpeedTouch 610 Operation And Maintenance Manual

7.2 Basic Navigation

Command group
navigation
Help
E-SIT-CTC-20030324-0002 v1.0
From top level, you can change to a command group by executing the name of the
desired command group (i.e. type the name of the command group and press ENTER).
To obtain a list of all available command groups, execute help from the top level:
=>help
Following commands are available :
help : Displays this help information
menu : Displays menu
? : Displays this help information
exit : Exits this shell.
.. : Exits group selection.
saveall : Saves current configuration.
Following command groups are available :
adsl atm
cip config
eth ethoa
ipoa ipsec
password phonebook
qosbook script
software switch
upnp
=>
The exact list of available command groups depends on the type of modem
Note
(SpeedTouch™610 ADSL/SHDSL/VDSL variant, networking interfaces), on
the number and kind of activated software modules (enabled software keys)
and on the current version of the SpeedTouch™610 System software.
To return to top level, or to go up one level (in case of nested command groups), type
two dots and press ENTER.
You can execute help or ? from any level to list all available commands and command
groups for that level. Below an example is provided of executing help from the firewall
command group selection:
=>firewall
[firewall]=>help
Following commands are available :
assign : Assign a chain to an entry point.
unassign : Clear a specific hook
list : Shows a list of all the hooks with the chains
attached.
flush : Clears all hooks, chains and rules
tron : Enables verbose console messaging.
troff : Disables verbose console messaging.
Following command groups are available :
chain rule
[firewall]=>
Executing help firewall from top level gives the same result.
7 SpeedTouch™610 Command Line Interface
atmf autopvc
dhcp dns
firewall grp
label language
pppoa pppoe
sip snmp
syslog system
bridge
env
ip
nat
pptp
sntp
td
53