Backup System Software Via Ftp - THOMSON SpeedTouch 610 Operation And Maintenance Manual

3 SpeedTouch™610 System Software

3.3.1 Backup System Software via FTP

Introduction
Backup procedure
20
For backup reasons, you can transfer system software files from both Speed-
Touch™610's '/active' and '/dl' subdirectories to your local disk.
To transfer system software files from the SpeedTouch™610 to your local disk as
backup, proceed as follows:
Open an FTP session to the SpeedTouch™610. At the user name prompt, enter a
1
user name (Note that by default entering a user name is not mandatory) and at
the password prompt, if applicable, the SpeedTouch™610 System Password (see
"2 The SpeedTouch™610 System Password" on page 7
Password):
C:\>ftp <SpeedTouch™610
Connected to <SpeedTouch™610
220 Inactivity timer = 120 seconds. Use 'site idle <secs>' to
change.
User (<SpeedTouch™610
331 SpeedTouch (00-90-D0-01-02-03) User 'JohnDoe' OK.
required.
Password:#####
230 OK
ftp>
Enter binary file transfer mode. Optionally you can enable hashing:
2
ftp> bin
200 TYPE is now 8-bit binary
ftp> hash
Hash mark printing On
ftp>
Change to the SpeedTouch™610 subdirectory from which you want to get the
3
system software file from.
In the example below the '/active' subdirectory is chosen where the currently run-
ning - and usually most recent - system software file is stored:
ftp>cd active
250 Changed to /active
ftp>
To identify the system software file name, execute the quote site software version
4
command.
ftp>quote site software version
200- Active SW
200- Passive SW
200-
200 CLI command "software version" executed
ftp>
IP address>
IP address>.
IP address>:(none)): JohnDoe
ftp: (2048 bytes/hash mark) .
: LLT5AA4.20H
: LLT5AA4.20F
to configure a System
Password
E-SIT-CTC-20030324-0002 v1.0