Vacon Graphical Keypad; Using The Graphical Keypad - Vacon 100 flow Applications Manual

vacon • 56
2.2

Vacon graphical keypad

Status field
Status field
READY/NOT READY/FAULT
STOP/RUN
Direction
STOP
ID:
Quick Setup
( 17 )

Monitor
( 5 )

Parameters
( 12 )
2.2.1

Using the graphical keypad

2.2.1.1 Editing values
The selectable values can be accessed and edited in two different ways on the graphical keypad.
Parameters with one valid value
Typically, for one parameter is set one value. The value is selected either from a list of values (see
the example below) or the parameter is given a numerical value from a defined range (e.g.
0.00...50.00 Hz).
Change the value of a parameter by following the procedure below:
1. Locate the parameter.
Edit
2. Enter the
3. Set the new value with the arrow buttons Up/Down. You can also move from digit to digit with
the arrow buttons Left/Right, if the value is numerical and then change the value with the
arrow buttons Up/Down.
4. Confirm the change with
Back/Reset button.
STOP READY

Start/Stop Setup
ID:172
Rem Control Place
I/O Control
KeypadStopButton
Start Function
Ramping
OR:
Figure 25. Typical editing of values on graphical keypad (text value)
2
ALARM
READY I/O
Main Menu
M1
9159.emf
Figure 24. Main menu
mode.
OK
button or ignore the change by returning to the previous level with
I/O STOP READY

M3.2.1 ID:
Edit
Help
Yes
Add to favorites
STOP READY I/O

Start/Stop Setup
ID:172 M3.2.1
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
User interfaces on Vacon®100 FLOW
Control place:
PC/IO/KEYPAD/FIELDBUS
Location field
(Parameter ID number and
current menu location
Activated group/item:
Press OK to enter
Number of items
in the group
I/O STOP

Rem Control Place
M3.2.1
STOP READY

Rem Control Place
M3.2.1
FieldbusCTRL
I/O Control
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
READY I/O
Rem Control Place
M3.2.1
FieldbusCTRL BACK
RESET
I/O Control
I/O