Vacon 100 flow Applications Manual page 183

Monitoring value and parameter descriptions
Graphical keypad
2. You are now in the
DigIN SlotA.
value
underlined. (Should you have more digital
inputs available in your I/O, for example,
through inserted option boards in slots C,
D or E, they can also be selected here.).
See Figure 65.
Arrow right
3. Push the
vate the terminal value
Arrow up
4. Push the
change the terminal value to
with OK button.
5. NOTE! If the digital input DI6 was already
used for some other function a message is
displayed. You might then want to change
either of these selections.
External fault close
Now, the function
16).
NOTE! The function is not assigned to any terminal, or, the the input is set to be always FALSE, if its
value is DigIN Slot0.1 (graphical keypad) or dI 0.1 (text keypad). This is the default value of the
majority of parameters in the group M3.5.1.
On the other hand, some inputs have been by default set to be always TRUE. Their value shows
DigIN Slot0.2 (graphical keypad) or dI 0.2 (text keypad).
NOTE! Also Time Channels can be assigned to digital inputs. See more information in Table 63.
Sleep function settings in chapter 4.
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
Table 121. Programming digital inputs
PROGRAMMING INSTRUCTIONS
Edit
mode as the slot
is blinking and
button again to acti-
3
.
button three times to
6
. Confirm
is controlled with a digital signal to digital input DI6 (terminal
Text keypad
Edit
2. You are now in the
is blinking. (Should you have more digital
inputs available in your I/O, for example,
through inserted option boards in slots C, D
or E, they can also be selected here.). See
Figure 65.
Arrow right
3. Push the
3
terminal value . The letter
Arrow up
4. Push the button three times to
change the terminal value to
OK button.
5. NOTE! If the digital input DI6 was already
used for some other function a message will
scroll through the display. You might then
want to change either of these selections.
vacon • 181
d
mode as the letter
button to activate the
d
stops blinking.
6
. Confirm with
8