Restarting Your Computer - Panasonic CF-35 Operating Instructions Manual

Starting Up/Shutting Down
Using the Touch Pad
Moving the cursor
Work Surface
Cursor
Clicking
One tap
NOTE
To change the touch pad settings, select [Mouse] in [Start] - [Settings] - [Control
Panel]. Even if [Left-handed] is selected in the mouse settings, tapping the touch
pad will have the same effect as clicking the left button of the touch pad.
Shutting Down (power off your computer)
(The display varies depending on the
models.)
Starting Up Your Computer Quickly
Differences between suspend function and hibernation function
Function
Suspend function
10 Hibernation function
Use the touch pad to move the cursor on the display and perform normal computer operations. It
is not necessary to apply too much pressure on the work surface.
CAUTION
Leaving your finger on the touch pad for more than 15 seconds will put your computer in
the Calibration mode. In this mode, there are instances where even if you slide your
finger on the work surface, the cursor will not move. In such cases, you have to lift your
finger from the work surface and apply your finger to the work surface again.
When using drawing applications like Paint, please try to draw in the center of the
work surface. There are cases where lines drawn later appear to have been drawn
incorrectly.
Double-clicking
or
Two quick
One tap
taps
1
To shut down, save all data and select [Shut Down] from the
[Start] menu
NOTE
From the keyboard,
you may choose to press down on
2
Confirm shutdown
Select [Shut down] (or [Shut down the computer?]), then press
Your computer will power off automatically.
(In the OFF state, if you are not recharging your battery pack or if the pack is fully charged, your computer and
the AC adapter consume approximately 1.1W.)

Restarting your computer

Select [Restart] (or [Restart the computer?]), then press
NOTE
To quickly resume computer operation after shutting down,
the suspend and hibernation functions are available. (
If you want to immediately start up and continue an application after shutting down your com-
puter, you can do so by using the suspend or hibernation function.
Where data is saved to
Memory
Hard disk
or
Two quick
taps
then select [Shut Down].
(without shutting down)
Speed Requires power supply
Fast Yes (if power is cut, all data is lost)
Somewhat slow Power not required to maintain data
Dragging
or
While holding
down the button,
moving your fin-
ger on the work
Two quick taps, but on
surface
the second tap leav-
ing your finger down
(applying pressure)
and moving it on the
work surface. One tap
when your finger will
"drop" the object.
(or
(or
below)
).
).