Setting The Supervisor Password - Panasonic CF-35 Operating Instructions Manual

Security Measures
20

Setting the Supervisor Password

(enabling, changing, disabling)
1
Run the Setup Utility
2
Using and
3
Using and
4
To enable or change your supervisor password
Enter your password at the [Enter Supervisor Password], then press
CAUTION
Your password will not be displayed on the screen.
Please limit your password to seven characters. Note that there is no dis-
tinction between upper and lower case letters.
White colored keys can be used. Note that space bar and function keys
cannot be used.
Do not input your password while holding down on the
Use only the upper horizontal row of numeric keys to input user pass-
words. The numeric keys combined with alphabet keys on the lower key-
board cannot be used.
Do not forget your password. If a password is forgotten you will be un-
able to use your computer.
To disable your supervisor password
Using and
step 7 .
5
Re-enter your password at the [Enter Supervisor Password
Again]
(This is for confirmation purposes.)
NOTE
When you do not want the User Password enabled, changed, or disabled
without permission,
use and
.
6
Using and
7
At the confirmation screen, press
8
Press to end the password setting procedure
9
Close the Setup Utility
( page 36)
, select [Supervisor Setup] then press
, select [Supervisor Password] then press
, select [Delete Supervisor Password] then press
to select [User Password Protection], then set [Enable] with
, select [Set Supervisor Password] then press
( page 36)
.
or .
. Go to