Panasonic CF-35 Operating Instructions Manual page 25

Cf-35 series personal computer
Table of Contents

Advertisement

Connecting a Port Replicator
Using an External Display
Ext. Display Port
Using a Printer
Parallel Port
A port replicator is available as an option (CF-VEB351). This device eliminates the hassles of
having you connect/disconnect the various cables when carrying your computer around and
allows a variety of peripherals to be connected including a headphone or microphone, etc.
The port replicator connects to the expansion bus connector on the bottom of your computer.
When your computer is not connected to the port replicator, be sure that the expansion bus
connector on the bottom of the computer is covered.
For more detailed information, please refer to the operation manual for the port replicator.
1
Power off your computer
Do not shut down using the suspend or hibernation mode.
CAUTION
Do not install or remove peripherals while your computer is in the suspend or hiber-
nation mode; abnormal operation may result.
2
Connect the external display to your computer
NOTE
For more detailed information, please refer to the operation manual for the external
display.
3
Turn on the display, then turn on your computer
To display on both the LCD of your computer and the external
display
1
Run the Setup Utility
2
Using
and
3
Using
and
then press
4
Close the Setup Utility
5
Select your external display
Set your external display for [Models] in [Start] - [Settings] - [Control Panel] -
[Display] - [Settings] - [Advanced Properties] - [Monitor] - [Change] - [Show all
devices], then press
1
Power off your computer
Do not shut down using the suspend or hibernation mode.
CAUTION
Do not install or remove peripherals while your computer is in the suspend or hiber-
nation mode; abnormal operation may result.
2
Connect the printer to your computer
NOTE
Some printer cables may be difficult to connect, and may require removal of the rear
cover. Take care not to lose the cover.
3
Turn on the printer, then turn on your computer
(
page 10)
(
page 36).
, select [System Setup] then press
, select [Display], set [Simultaneous] with
(
page 36).
.
(
page 10)
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents