Installing The Pc Card - Panasonic CF-35 Operating Instructions Manual

Cf-35 series personal computer

Hide thumbs

Table of Contents

Using PC Cards

PC Card Slots

Button

Label-side up

NOTE

You may need to install a driver from the Windows 95 CD-ROM (included) or a PC Card's floppy disk. Simply follow the

on-screen instructions and read the PC Card's operation manual on how to install the driver.

PhoenixCard Manager95:

Follow the installation procedure below only if you will be using the ZV card. Otherwise, do not perform the installa-

tion; abnormal operation may result.

1 Set [Sound Chip] to [Automatic (PnP)] in the Setup Utility.

2 Select [Start] - [Run] and type [c:\util\phoenix\disk1\setup.exe] press

structions.

If PhoenixCard Manager95 has been reinstalled, follow the instructions in "Installing PhoenixCard Manager95" on

page 34.

After PhoenixCard Manager95 has been installed, make sure to power off the computer before installing or removing

the card. Also, do not use the suspend or hibernation functions if the card is installed.

Your computer has two PC Card slots. These slots conform to the PC Card Standard; there-

fore, communications and SCSI devices may be utilized. The slot allows you to use two Type

I or Type II cards (or one Type I and one Type II), or one Type III card.

Type I or II

Two cards can be used simultaneously.

CAUTION

Please check the PC Cards' specifications. Be sure the total operating current does

not exceed the specified limit. Damage may result otherwise.

Allowable Current (total for two slots) : 3.3 V: 400 mA, 5 V: 400 mA, 12 V: 120 mA

There are times when both a Type I card and a Type II card will not work at the same time.

SRAM and FLASH ROM (except for ATA interface) cards are not supported.

When using a CardBus type card, use only that card; do not insert any other PC Cards.

Only the bottom slot can support a Zoomed Video (ZV) card.

Installing/Removing the PC Card

Power off your computer

Do not shut down using the suspend or hibernation mode.

CAUTION

Do not install or remove peripherals while your computer is in the suspend or

hibernation mode; abnormal operation may result.

Before removing a PC Card, go to [Socket Status] (in [Start] - [Settings] - [Control

Panel] - [PC Card (PCMCIA)]), select the PC Card slot and press [Stop].

Removing the PC Card

Pull the button out and then press it.

NOTE

Dummy cards are provided at the time of purchase. They provide protection

for the PC Card slots against such things as dust.