Initial Setup Menu - Furuno TZTL12F Operator's Manual

Menu item
[Bearing Display]
[True Wind Calculation
Reference]
[Position Format]
[Short/Long Change Over] Set the distance at which to change between short and long range. Set
[Range (Long)]
[Range (Short)]
[Depth]
[Height/Length]
[Fish Size]
[Temperature]
[Boat Speed]
[Wind Speed]
[Atmospheric Pressure]
[Oil Pressure]
[Volume]
[Reset Default Settings]
13.3

Initial Setup Menu

The [Initial Setup] menu, which is mainly for use by the installer of the equipment, sets
up the system according to the sensors connected. These adjustments require some
knowledge of marine electronics equipment. If you are unsure of your abilities, have a
qualified marine electronics technician make the adjustments. Inadequate adjustment
can affect performance.
GPS POSITION section
Menu item
[Longitudinal (from
bow]
[Lateral GPS Position
(-Port)]
BOAT INFORMATION section
Menu item
[Boat Length]
[Size of Static Icon]
[Depth Display]
[Transducer Draft]
[Keel Draft]
[Magnetic], [True]
The mode (magnetic or true) of all heading and bearing data.
[Ground], [Surface]
Select wind value to display from speed over ground or speed through
water (surface).
[DDD°MM.mmmm'], [DDD°MM.mmm'], [DDD°MM.mm'],
[DDD°MM'SS.ss'], [DDD.dddddd°]
the long range here (0.0 to 2.0 NM)
[Nautical Mile], [Kilometer], [Mile]
[Foot], [Meter], [Yard]
[Foot], [Meter], [Fathom], [Passi Braza]
[Foot], [Meter]
[Inch], [Centimeter]
[Fahrenheit Degree], [Celsius Degree]
[Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[HectoPascal], [Millibar], [Millimeter of Mercury], [Inch of Mercury]
[KiloPascal], [Bar], [Pound per Square Inch]
[Gallon] (Gallon & Gallon/Hour), [Litre] (Litre & Litre/Hour)
Restore default settings for the [Units] menu.
Description
Enter the GPS antenna posi-
tioning bow-stern (Longitudi-
nal) and port-starboard
(Lateral) position from the
origin.
Description
Set the length of your boat.
Set the size of static (such as own ship)
icons.
Select the start point for depth measure-
ment.
Set the transducer draft.
Set the keel draft.
13. OTHER FUNCTIONS
Options
Options (setting range)
0 m to 999 m
-99 m to +9 m
Origin Origin
Options (setting range)
0 (m) to 999 (m)
50 to 150
[Under Keel],
[Under Sea Level]
0.0 (m) to 99.9 (m)
0.0 (m) to 99.9 (m
13-3