Ad/Da Converter - RME Audio ADI-2 Pro User Manual

17.3 AD/DA Converter

AD/DA: Converter Mode, analog in to all digital outs, digital in to all analog outs.
This mode can be activated manually by selecting Basic Mode – AD/DA. The device enters
AD/DA mode automatically when Basic Mode is set to Auto and a digital input signal is de-
tected.
The detected digital input signal will also become the signal source. In case more than one digi-
tal signal is found the user has to manually select the source to be monitored (I/O – Output
Channel - Settings – Source). The SRC is active as default, assigned to SPDIF. Clock mode is
slave to AES in, but will adapt to the detected source (Auto).
Note: To simplify the diagram and to maintain overview USB record is not shown. In all modes
all input signals are sent over USB to the host. In multi-channel mode three separate stereo
pairs, in stereo mode only the stereo analog input.
USB Playback channels 3/4 can only be monitored in multi-channel mode. In stereo mode se-
lecting USB 3/4 plays channels 1/2.
User's Guide ADI-2 Pro © RME
33