Parametric Eq - RME Audio ADI-2 Pro User Manual

Phase Invert
Available settings are Off, Both, Left and Right. Inverts the phase (180°) on the corresponding
channel.
AD Filter
SD Sharp or SD Slow. The analog to digital conversion can be done using two different filters.
Default is SD Sharp, offering the widest and most linear frequency response. Alternatively SD
Slow can be used, causing a small drop in the higher frequency range, but offering a less ag-
gressive (less steep) filter. Both filters are short-delay filters for minimized latency/delay of the
audio signal.
Dual EQ
Off or On. When set to on, the 5-band parametric equalizer can be set individually for left and
right channel.
AD Conversion
PCM or DSD. Default: PCM. When selecting DSD the current DSD rate is shown as well. It
changes with the chosen sample rate (SETUP - Options - Clock). DSD is available as USB
record signal only when USB is set to CC mode stereo.

12.1.2 Parametric EQ

Subpage Parametric EQ has the following entries:
EQ Enable
On or Off.
Band 1 Type
Available settings are Peak, Shelf or Low Cut.
Band 2-4 Type
Available settings are Peak and Shelf.
Band 5 Type
Available settings are Peak, Shelf or High Cut.
Band 1-5 Gain
Available settings are -12 to +12 dB in steps of 0.5 dB.
Band 1-5 Frequency
Adjustable from 20 Hz to 20.0 kHz in steps between 1 Hz and 100 Hz.
Band 1-5 Q
Quality factor is adjustable from 0.5 to 5.0 in steps of 0.1. This equals a bandwidth setting of
2.54 to 0.29.
Subpage Parametric EQ R is only shown with Dual EQ set to On. It has the exact same
entries as listed above.
User's Guide ADI-2 Pro © RME
20