RME Audio ADI-2 Pro User Manual page 24

The EQ can cause distortion for the digital outputs when used on the Analog Input. Again the
level meters will clearly show this error condition. Reduce the input's sensitivity by selecting a
higher Reference Level in such a case.
If the frequency graph is shown as grey line the EQ is
disabled. There are two ways to change this state:
Push key EQ again to change to the page EQ Enable /
Presets, see below.
Push key I/O, select current channels, Subpage
Parametric EQ, EQ Enable On or OFF
Pushing the EQ key a second time brings up the EQ Enable / Presets screen. In this screen
the EQ can be switched on and off, and EQ presets can be stored and loaded comfortably.
Use encoder 1 to change between the subpages Analog Input, Main Output 1/2 and Phones
Out 3/4. These subpages have the following entries:
EQ Enable
Default: OFF. Options are ON, OFF, L, R (L and R are only
available with Dual EQ activated).
Preset Select
Load or store up to 22 different EQ settings. The first choice,
Manual, holds the current, unsaved EQ settings. The second
choice, Temp, holds the settings of a loaded and then modi-
fied Preset. This scheme lets the user easily change and
compare three different EQ settings: the manual one, the
stored preset and the modified preset, without loosing
changes while listening to a different set of EQ settings.
The presets are independent from and not stored with Setups (see chapter 14.2). EQ Presets
are therefore always available, no matter which Setup has been loaded. The Setup does in-
clude the current EQ setting, which on load is written into the memory slot Manual.
Name
Allows to edit the name of the current preset and to edit the
name during the store process. Turn encoder 2 to select a
letter, number or symbol, then press encoder 2 briefly to
enter the next sign. After the last sign the cursor jumps to the
field Store to. The name can consist of up to 14 signs.
Turning encoder 1 gives access to all existing preset names,
so copying and modifying a preset can be done more
quickly.
Changing the name is always stored immediately during
editing, without further confirmation.
Leaving this field the name is automatically adjusted to the right. Adding signs to the front and
rear is possible afterwards. A quick turn to the left brings up space, which is also used to quickly
delete letters. Available signs are:
Space, Aa to Zz, + - / ( ) * ; : . , ! # $ & < > = ' I @, 0 - 9
Save to
Use encoder 2 to select the slot where the current preset should be stored to. To store press
and hold encoder 2 for one second.
24
User's Guide ADI-2 Pro © RME