Bass/Treble; Loudness - RME Audio ADI-2 Pro User Manual

Balance
Mirrors the balance control in the VOL screen. Adjustable from L 100 (left) through <C> (center)
to R100 (right).

12.2.2 Bass/Treble

Subpage Bass/Treble has the following entries:
Bass Gain
Current Bass amplification for the current channels as set
by encoder 1 (B). Adjustable between -6 dB and +6 dB in
steps of 0.5 dB.
Bass Freq
Corner frequency of the shelf bass filter. Adjustable from
20 Hz to 150 Hz in steps of 1 Hz. Default: 85 Hz.
Bass Q
The quality factor of the filter is adjustable from 0.5 to 1.5.
Default 0.9.
Treble Gain
Current Treble amplification for the current channels as set by encoder 2 (T). Adjustable be-
tween -6 dB and +6 dB in steps of 0.5 dB.
Treble Freq
Corner frequency of the shelf treble filter. Adjustable from 3 kHz to 10 kHz in steps of 100 Hz.
Default: 6.5 kHz.
Treble Q
The quality factor of the filter is adjustable from 0.5 to 1.5. Default 0.7.

12.2.3 Loudness

Subpage Loudness has the following entries:
Enable
On or Off.
Bass Gain
Maximum Bass amplification. Adjustable between 0 dB and +10 dB in steps of 0.5 dB. Default:
+7 dB
Treble Gain
Maximum Treble amplification. Adjustable between 0 dB and +10 dB in steps of 0.5 dB. Default:
+7 dB
Low Vol Ref
Reference level for highest Bass/Treble amplification,
referenced to the Volume set in dB. Available range is -40
dB to -20 dB. Default: -30 dB. A volume setting below this
point will have maximum Bass/Treble gain, all volume
settings above this point will have lower Bass/Treble gain.
20 dB above the Low Vol Ref setting the Bass/Treble gain
will be zero.
User's Guide ADI-2 Pro © RME
22