Toyota land cruiser prado Owner's Manual page 134

With the vehicle stability control
D
system—The warning buzzer comes
on together with the warning light.
In either case, this can indicate that
the brakes may not work properly
and your stopping distance will be-
come longer. Depress the brake
pedal firmly and bring the vehicle
to an immediate stop.
The brake system warning light re-
D
mains on together with the "ABS"
warning light.
In this case, not only the anti−lock
brake system will fail but also the
vehicle will become extremely un-
stable during braking.
With the vehicle stability control sys-
tem—
Any of the following conditions may oc-
cur, but do not indicate the malfunc-
tion:
The light may stay on for about 60
D
seconds after the engine switch is
turned to the "ON" position. It is nor-
mal if it turns off after a while.
Depressing the brake pedal repeatedly
D
may turn on the warning light and
buzzer. It is normal if the light turns off
and the buzzer stops sounding after a
few seconds.
You may hear a small sound in the
D
engine compartment after the engine is
started or the brake pedal is depressed
repeatedly. This is a pump pulsating
sound of the brake system, and it is
not a malfunction.
(b) Driver's Seat Belt Reminder Light
The light acts as a reminder to buckle up
the driver's seat belt.
Once the engine switch is turned to "ON"
or "START", the reminder light flashes if
the driver's seat belt is not fastened. Un-
less the driver fastens the belt, the light
continues flashing.
(c) Front Passenger's Seat Belt Re-
minder Light
The light acts as a reminder to have the
front passenger buckle up the seat belt.
Once the engine switch is turned to "ON",
the reminder light flashes if a passenger
sits in the front passenger seat and does
not fasten the seat belt. However, if a
front passenger uses an additional seat
cushion, the light may not flash even
when the seat belt is not buckled up.
If luggage or other load is placed on the
front outside passenger seat, depending
on its weight and how it is placed on the
seat, built−in sensors in the seat cushion
may detect the pressure, causing the re-
minder light to flash.
125