Toyota land cruiser prado Owner's Manual page 94

Types of seat belts
There are two types of seat belt. Check
the type before installing a child restraint
system.
ALR/ELR (Automatic Locking Retractor/
Emergency Locking Retractor) belt—
This belt locks when the belt is pulled out
quickly. Also, this belt has an additional
fully−extended lock mode;
shoulder belt is completely extended and
is then retracted even slightly, the retrac-
tor locks the belt in that position and the
belt cannot be extended. When installing
a child restraint system, fully extend the
belt to put it in the lock mode.
ALR/ELR belts are equipped for the sec-
ond seat belts.
ELR (Emergency Locking Retractor) belt—
This belt also locks when the belt is
pulled out quickly but it does not have an
additional fully−extended lock mode. When
installing a child restraint system, you will
need a locking clip.
If your child restraint system does not
provide a locking clip, you can purchase
the following item from your Toyota dealer.
Locking clip for child restraint system
(Part No. 73119−22010)
—Types of child restraint
system
Child restraint systems are classified into
the following 3 types depending on the
child's age and size.
(A) Baby (infant) seat
(B) Child (convertible) seat
(C) Junior (booster) seat
Install the child restraint system following
the instructions provided by its manufac-
turer.
When the
An ISOFIX child restraint system approved
for your vehicle may also be used. See
"—Installation with ISOFIX rigid anchors"
on page 99 in this Section.
(A) Baby (infant) seat
(B) Child (convertible) seat
85