Table of Contents
Advertisement
PRECAUTIONS FOR PROPER USE
Fiber
Mounting FT-Z8
and FT-WZ8
Mount the fiber head by using the enclosed set of screws.
The tightening torque should be 0.15 N m or less
If the fiber head is mounted in places subject to vibrations
or shocks, use a screw-locking adhesive, etc.
Mount each fiber head as given below.
<
FT-Z8 / FT-WZ8 (Front sensing type)
In case of tapping the mounting section
In case of using attached screw and nut
<
FT-Z8E / FT-WZ8E (Side sensing type)
In case of tapping the mounting section
In case of using attached screw and nut
>
>
08/2005
<
FT-Z8H / FT-WZ8H (Top sensing type)
In case of tapping the mounting section
In case of using attached screw and nut
Mounting FT-Z802Y
Using M3 pan head
screws, the tightening
torque should be
0.3 N m or less.
Mounting FD-WKZ1
<
If not using the attached mounting brackets
Use M3 or less set screws (cup point), and affix the head
within 15 mm
0.591 in
from the tip of the fiber head. Do
not exceed a torque of 0.3 N m when tightening.
<
If using the attached mounting brackets
The head can be affixed even without using the set
screws.
If using the set screws, use M3 set screws (cup point) to
affix and do not exceed a torque of 0.05 N m when
tightening.
Mounting FD-A15
Using M3 screws, the tightening torque should be 0.3 N m
or less.
Mounting FD-H30-L32 / FD-H18-L31
Using M3 screws, the tightening torque should be 3 N m
or less.
FX-301
>
>
>
101
Advertisement
Table of Contents
