Bang & Olufsen BeoSystem 1 User Manual page 36

36
Identify source for RF input
If you have not connected a cable box to the
RF IN A socket on the BeoSystem 1 top
connection panel, the menu shown below
appears. Register the source or type of signal
connected.
RF SETUP
INPUT A CABLE
INPUT B NONE
modify store
INPUT A options on the RF SETUP menu
CABLE
Choose this option if a cable signal is connected
to the RF IN A socket.
ANTENNA
Choose this option if an antenna signal is
connected to the RF IN A socket.
NONE
Choose this option if no signal is connected to
the RF IN A socket.
*NOTE! For further information about the menu
for adding or removing channels, please refer to
Edit and fine tune channels.
>> Gain access to channels – Identify source for RF input
Auto tune with no cable box
If you have not connected a cable box, but
you have connected an RF signal to the
RF IN A socket on the BeoSystem 1 top
connection panel, the following menu
sequence appears.
RF SETUP
CABLE BOX NONE
INPUT A
INPUT B
store
modify
AUTO TUNING
skip
ADD / REMOVE CHANNELS
RF INPUT
ADD CHANNEL
REMOVE CHANNEL
add
With e.g. TV switched on...
> Press MENU on Beo4 to call up the main
RF SETUP
TV SETUP menu.
CABLE
> Press 8 to call up the RF / CHANNEL SETUP
NONE
menu.
> Press GO to call up the RF SETUP menu.
ss tt
> Press or
next RF SETUP menu appears.
> Enter the type of source connected for INPUT A
and press GO to store.
> If the AUTO TUNING menu appears, press
start automatic tuning, or press
store
automatic tuning.
If tuning has been performed, the ADD / REMOVE
menu* appears. Complete your channel setup by
adding or removing channels. Press GO when you
are done.
start
ANT
4
- -
done
to reveal NONE and press GO. The
tt
to
ss
to skip