Bang & Olufsen BeoSystem 1 User Manual page 34

34
If you connect BeoSystem 1 to either
a cable network or antenna, all
channels are then available. However,
you must complete the tuning
procedure and select which channels
you wish to skip or store.
If you connect an RF cable box to RF
Input A on the top of BeoSystem 1,
then you have to complete the RF
setup. Identify the type of socket the
box is connected to and find the
output channel that gives access to
your cable box.
If automatic tuning is required, the
AUTO TUNING menu appears on the
screen.
All the fill-in menus concerning the
RF setup and the various options in
each menu will be explained on the
following pages. Two cases are
described in detail: one assuming a
setup with a cable box, and one
assuming a setup without a cable
box.
*NOTE! When you connect an RF cable box,
remember to leave it switched on at all times.
Gain access to channels – RF setup
RF/Channel setup menu
To gain access to the menus required for the
RF setup, call up the RF / CHANNEL SETUP
menu. Here, you can gain access to functions
for editing channels – adding or removing
channels, fine tuning, and selection of sound
type or SAP (Second Audio Program).
RF / CHANNEL SETUP
1 RF SETUP
2 ADD / REMOVE CHANNELS
3 FINE TUNE
select
While BeoSystem 1 is on...
> Press MENU on Beo4 to call up the main
TV SETUP menu.
> Press 8 to call up the RF / CHANNEL SETUP
menu.
> Press the number button that corresponds to
the menu item you want:
1 – ensure access to channels
2 – add or remove channels
3 – fine tuning or mono/stereo/SAP selection.
> Or, use to step to the item you want and
▼ ▲
press GO to call up the selected menu.
Once you have completed menu operations...
> Press EXIT or a source button, e.g. TV or SAT,
to exit all menus or press STOP to back up
through previous menus.
Identify the cable box socket
Once you have connected a cable box* to a
socket on the BeoSystem 1 top connection
panel, you must register the connection in the
RF SETUP menu.
RF SETUP
CABLE BOX NONE
modify accept
Options for CABLE BOX on the RF SETUP
menu
NONE
Choose this option if you have not connected a
cable box to BeoSystem 1.
RF INPUT A
Choose this option if you have connected a RF
cable box to the RF IN A socket on the
BeoSystem 1 top connection panel.
STB INPUT
Choose this option if you have connected a
digital cable box to the STB sockets on the
BeoSystem 1 rear connection panel.
V.AUX INPUT
Choose this option if you have connected a
cable box to the V AUX sockets on the
BeoSystem 1 rear connection panel.