Bang & Olufsen BeoSystem 1 User Manual page 19

To facilitate remote control operation
of your BeoSystem 1 and all
connected equipment, you must
connect the IR receiver to
BeoSystem 1.
The IR receiver is a kind of 'eye',
which is cabable of receiving signals
from your Beo4 remote control and
sending them to BeoSystem 1.
BeoSystem 1 then sends the
appropriate control signals to your
screen, projector or other connected
equipment.
Connect the IR receiver
When mounting the IR receiver in a setup
with a plasma screen, make sure to place the
receiver on the same wall as the screen. If the
IR receiver is placed incorrectly, the light
emitted by the screen can impede remote
control operation of BeoSystem 1!
To connect the IR receiver...
> Detach the IR receiver's rear cover (unscrew the
two (C) screws and loosen the two (D) screws,
then lift off the cover).
> Cut the included cable to the required length
and strip the cable.
> Insert the cable end through the cable clamp (E)
and connect the leads to the terminals inside
the receiver in the order indicated. Tighten the
clamp.
> Attach the rear cover and fasten the IR receiver
to the wall as described below.
> Connect the cable to the IR RECEIVER socket on
the BeoSystem 1 top connection panel.
To fasten the IR receiver to the wall...
> Using the wall bracket as a template, mark and
drill two holes in the wall.
> Using the two screws and wall plugs supplied
(A), fasten the wall bracket to the wall.
> When you have mounted the receiver cable (as
described above), hang the receiver on the wall
bracket and then secure it with screw (B).
> Fasten the cable to the wall and run it to the
BeoSystem 1.
D
C
C
D
B
A
A
Green
Yellow
Brown
E
19