Bang & Olufsen BeoSystem 1 User Manual page 25

Connect a plasma screen
The instructions below assume a setup with
BeoSystem 1 and a plasma screen supported
by Bang & Olufsen. Contact your Bang &
Olufsen retailer for information about how to
connect and use BeoSystem 1 with other
screen types.
> Run the 15-pin plug end of the appropriate
cable to the PROJ. OUT socket on the
BeoSystem 1 top connection panel.
> Connect the plugs at the other end of the cable
to the sockets on the plasma screen in the
manner described in the screen's own user's
guide.
> Connect the IR receiver to BeoSystem 1 as
explained in Connect the IR receiver.
> If your plasma screen has an IR transmitter,
please refer to Connect video signals for
instruction in how to connect an IR transmitter.
> If your plasma screen does not have an IR
transmitter, connect the appropriate cable to the
DATA socket on the BeoSystem 1 rear
connection panel, and the other end to your
plasma screen.
Connect a projector
> Connect a low-power IR transmitter to the
PROJ-CTRL socket on the BeoSystem 1 rear
connection panel, and mount it near the IR
receiver on the projector. This enables you to
operate the projector with Beo4.
> Connect the IR receiver to the IR RECEIVER
socket on the BeoSystem 1 top connection
panel, and mount the IR receiver as explained in
Connect the IR receiver.
> Complete your projector setup.
Connect a Home automation system
> Connect your projector to BeoSystem 1 as
described to the left.
> Connect the Home automation system to the
DATA socket area on the BeoSystem 1 rear
connection panel.
> Connect the IR receiver to the IR RECEIVER
socket on the BeoSystem 1 top connection
panel, and mount the IR receiver as explained in
Connect the IR receiver.
> Complete your curtain, light and screen
controller system setup.
25