Vega VEGAPULS 67 Operating Instructions Manual page 51

Additional adjustments -
HART mode
Additional adjustments -
Copy instrument settings
VEGAPULS 67 • 4 ... 20 mA/HART - four-wire
Menu Menu item
Display Language
Displayed value
Display unit
Scaling size
Scaling
Backlight
Additional adjust- Distance unit
ments
Temperature unit
Probe length
Linearisation
curve
HART mode
The sensor offers the HART modes standard and Multidrop. In this
menu item you determine the HART modes and enter the address
with Multidrop.
The mode standard with the fixed address 0 means output of the
measured value as 4 ... 20 mA signal.
In Multidrop mode, up to 63 sensors can be operated on one two-wire
cable. An address between 1 and 63 must be assigned to each sen-
sor.
1)
The default setting is standard with address 0.
The instrument settings are copied with this function. The following
functions are available:
•
Store data from the sensor into the indicating/adjustment module.
•
Store data from the display and adjustment module in the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional settings" the items "Distance unit, tem-
perature unit and linearization"
•
The values of the user programmable linearization curve
The 4 ... 20 mA signal of the HART sensor is switched off. The sensor
1)
consumes a constant current of 4 mA. The measuring signal is transmitted
exclusively as digital HART signal.
6 Set up with the display and adjustment module
Default value
Like order
Distance
m
Volume
l
0.00 lin %, 0 l
100.00 lin %, 100 l
Switched on
m
°C
Length of the standpipe Ex factory
Linear
Standard
Address 0
51