Vega VEGAPULS 67 Operating Instructions Manual page 14

4 Mounting
14
Fig. 3: Radar sensor with mounting strap
The strap is supplied unassembled and must be screwed to the
sensor before setup with three hexagon socket screws M5 x 10 and
spring washers. Max. torque, see chapter "Technical data". Required
tools: Allen wrench size 4.
There are two ways to screw the strap onto the sensor. Depending
on the selected version, the sensors can be swivelled in the strap as
follows:
•
Single chamber housing
– Angle of inclination 180°, infinitely variable
– Angle of inclination in three steps 0°, 90° and 180°
•
Double chamber housing
– Angle of inclination 90°, infinitely variable
– Angle of inclination in two steps 0° and 90°
Fig. 4: Adjustment of the angle of inclination
VEGAPULS 67 • 4 ... 20 mA/HART - four-wire