Appendix B
Sample Configurations
Figure B-6
VLANs 200-202
See the following sections for the configurations for this scenario:
•
•
•
Example 6: Primary FWSM Configuration
The following sections include the configuration for the primary FWSM:
•
•
•
•
Example 6: System Configuration (Primary)
You must first enable multiple context mode using the mode multiple command. Then enter the
activation key to allow more than two contexts using the activation-key command. The mode and the
activation key are not stored in the configuration file, even though they do endure reboots. If you view
OL-6392-01
Example 6
Active Switch
MSFC
HSRP IPs:
10.0. n .4
Primary
FWSM
Mgmt IPs:
10.0.3.1
10.0.1.1
10.0.2.1
VLAN 4
VLAN 5
VLAN 6
Example 6: Primary FWSM Configuration, page B-19
Example 6: Secondary FWSM System Configuration, page B-21
Example 6: Switch Configuration, page B-21
Example 6: System Configuration (Primary), page B-19
Example 6: Context A Configuration (Primary), page B-20
Example 6: Context B Configuration (Primary), page B-20
Example 6: Context C Configuration (Primary), page B-21
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
Internet
VLAN 100
Standby Switch
Failover Links:
VLAN 10
Trunk:
VLANs 200, 201,
VLAN 11
202, 4, 5, 6, 10, 11
Mgmt IPs:
10.0.1.2
Context A
Context B
Context C
Transparent Mode Examples
MSFC
HSRP IPs:
10.0. n .4
Secondary
FWSM
10.0.3.2
10.0.2.2
B-19