Viewing The Current Logged-In User - Cisco Catalyst 6500 Series Configuration Manual

Viewing the Current Logged-In User

Be sure to configure users in the local database (see the
page
section on page
Viewing the Current Logged-In User
To view the current logged-in user, enter the following command:
FWSM/contexta# show curpriv
See the following sample show curpriv command output. A description of each field follows.
FWSM/contexta# show curpriv
Username : admin
Current privilege level : 15
Current Mode/s : P_PRIV
Table 12-2
Table 12-2 show curpriv Display Description
Field
Username
Current privilege level Level from 0 to 15. Unless you configure local command authorization and
Current Mode/s
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
12-18
12-6) and command privilege levels. (See the
12-10.)
describes the show curpriv command output.
Description
Username. If you are logged in as the default user, the name is enable_1
(unprivileged) or enable_15 (privileged).
assign commands to intermediate privilege levels, levels 0 and 15 are the only
levels that are used.
Shows the access modes:
P_UNPR—Unprivileged mode (levels 0 and 1)
•
P_PRIV—Privileged mode (levels 2 to 15)
•
P_CONF—Configuration mode
•
"Configuring the Local Database" section on
"Configuring Local Command Authorization"
Chapter 12 Configuring AAA
OL-6392-01