Installing Application Software To Any Application Partition - Cisco Catalyst 6500 Series Configuration Manual
Catalyst 6500 series switch and
cisco 7600 series router firewall services
Hide thumbs
Also See for Catalyst 6500 Series:
- Software configuration manual (570 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Chapter 16
Managing Software and Configuration Files
•
For example, to copy the application software from a TFTP server, enter:
FWSM# copy tftp://209.165.200.226/cisco/c6svc-fwm-k9.2-1-1.bin flash:image
To copy the application software from an FTP server, enter:
FWSM# copy ftp://admin:letmein@209.165.200.227/cisco/c6svc-fwm-k9.2-1-1.bin;type=ip
flash:image
To copy PDM from an HTTPS server, enter:
FWSM# copy http://admin:letmein@209.165.200.228/pdm/pdm-411.bin flash:pdm
Installing Application Software to Any Application Partition
If you log into the maintenance partition, you can install application software to either application
partition (cf:4 or cf:5).
The FWSM maintenance partition can only use VLAN 1 on the switch. The FWSM does not support
Note
802.1Q tagging on VLAN 1.
If you are running maintenance software release 1.1, the activation key, if present, is removed and the
mode reverts to single context mode. We suggest that you upgrade the maintenance software to Release
2.1 or later to keep the activation key and mode. See the
page 16-5
the
show version.
To install application software from an FTP server while logged into the maintenance partition, follow
these steps:
To boot the FWSM into the maintenance partition, enter the command for your operating system:
Step 1
•
•
OL-6392-01
an—ASCII normal mode
–
ip—(Default) Binary passive mode
–
in—Binary normal mode
–
Use binary for image files.
To copy from an HTTP or HTTPS server, enter the following command:
FWSM# copy http[s]://
[ user [: password ]@] server [: port ][/ path ]/ filename flash:[image | pdm]
The image option (default) copies the application software, and the pdm option copies the PDM
software.
to upgrade. To view the maintenance software version, log into the maintenance partition (see
"Installing Application Software to Any Application Partition" section on page
For Cisco IOS software, enter the following command:
Router# hw-module module mod_num reset cf:1
For Catalyst operating system software, enter the following command:
Console> (enable) reset mod_num boot cf:1
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide
Installing Application or PDM Software
"Installing Maintenance Software" section on
16-3), and enter
16-3
Advertisement
Table of Contents
Troubleshooting
